The set up of a new rest room vanity and countertop can transform an outdated rest room into a modern one. Installing a vanity and countertop is simple to do and can be bought from any family home advancement store for significantly less than $500.
Get rid of the old Vanity and Countertop
Initial turn off the water materials beneath the vanity. Upcoming disconnect the supply lines at the valves. Then disconnect the drain pipe at the trap (the j-formed section underneath the vanity). Future do away with the corner screws that are securing the top of the previous vanity to the countertop. The countertop should certainly then be capable to be lifted off of the outdated vanity.
Once the countertop has been separated from the vanity, remove the faucet hardware if you program on reusing the current faucet. Make guaranteed, although, when purchasing your new vanity countertop that it will help the faucet configuration (one particular hole or a few holes � and the variety of inches in between the holes � middle to middle).
Following the countertop and faucet have been taken out from the succeed place, unscrew the back again and/or aspect screws that maintain the vanity to the wall(s). Then eliminate the vanity from the bathroom.
Putting in the new Vanity and Countertop
Slide the new vanity into the area the place the preceding vanity resided. Notice: you will very likely would need to eradicate/reduce away a portion of the back of the new vanity to make it easy for the supply lines and drainage pipe to slide by using. A jig saw will work fine for this effort. Just make a couple of pilot holes with a drill and then use the jig observed to reduce out the proper place.
As soon as the vanity is in place, you will have to have to square it up with the back again or aspect walls and make guaranteed it sits stage. If there are imperfections in the partitions when attempting to square it up (e.g. the partitions are not straight), you can both scribe the vanity or use a small-scale piece of trim to conceal any imperfections. Scribing calls for employing a compass and reducing/shaving away a strip of the vanity edge this kind of that the full length of the cabinet edge sits evenly against the wall.
In order to level the vanity, shims may well be important to temporarily hold the vanity in area. Make positive the vanity is stage back to front and side to side. Then, employing screws fasten the vanity to the walls. Make positive the screws are securely fastened to studs powering the sheetrock.
When the vanity has been secured, it is now time to tackle the new countertop.
It is ideal to mount the faucet assembly to the countertop before inserting the countertop onto the vanity. When the faucet/provide lines and drain pipe have been put in to the countertop you are all set to place the countertop onto the vanity. However, it is most useful to lay a bead of Liquid Nails (caulk adhesive) along the leading of the vanity very first. This will assistance to guarantee that the countertop stays securely fastened to the vanity. In some cases, this could perhaps be all that is necessary or wanted for securing the countertop to the vanity.
Site the countertop on top notch of the vanity earning guaranteed it sits square. Use screws to protected the vanity to the countertop. More often than not there are corner blocks on the vanity to protected the screws to the countertop. Make certain, regardless, that you use screws that will not penetrate because of the the best of the vanity.
Last of all connect the supply line feeds (dangling down from the faucet) to the copper supply lines. Then connect the drain pipe of the bowl/sink to the J-Trap drainage pipe.
Turn on the scorching/cold h2o provide line valves and you are undertaken.
Writer: Mark J. Donovan
No comments:
Post a Comment